KitchenAid KDTF924PPS Owners Manual - Page 28

Complete Installation WARNING Install Access Panel 35. Install the toe panel Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 33. Power supply cord - Plug into a grounded 3 prong outlet Install the toe panel as shown in the above image. 36. Check toe panel edge B CD Check that the lower edge of the toe panel touches the floor. A Adjust if necessary. IMPORTANT: If there is visible gap to the floor after installing the toe panel, replace it with alternate (tall) toe panel supplied with dishwasher, shipped at the back of the dishwasher. A. Junction box cable B. Junction box C. Cable fittings (2) D. Power cord Plug into a grounded 3-prong outlet. 34. Reconnect power Reconnect electrical power at the fuse box or circuit breaker box. NOTE: With the access panel off, start the dishwasher and allow it to complete the shortest wash cycle. After the first 2 minutes, unlatch door, wait 5 seconds, and then open door. Check that there is water in the bottom of the dishwasher tub. Check that dishwasher is working properly. 37. Install access panels Place the access panel against dishwasher legs. Using a Phillips screwdriver or 1/4" nut driver, reinstall the screws through the holes in the access panel. 28