Kyocera ECOSYS P7240cdn P6235cdn/P7240cdn Operation Guide - Page 213

Troubleshooting > Troubleshooting Symptom Printouts are fuzzy. Printouts are cut off. Images are skewed. Checkpoints Corrective Actions Reference Page Is the machine being used in conditions Use in an environment that has suitable ― of very humid, or humidity or humidity. temperature rapidly changes? ― Select the [Menu] key > [Adjust/Maint.] ― > [Service Setting] > [Drum], and then select [Yes]. ― ECOSYS P7240cdn: Select the [Menu] ― key > [Adjust/Maint.] > [Service Setting] > [Drum Heater], and then select [On]. NOTE This function cannot be turned on in some regions. Is the paper loaded correctly? Check the position of the paper width guides. page 3-4 Irregular horizontal lines ― appear in the image. The altitude is 1000 m or ― higher and irregular horizontal white lines appear in the image. ECOSYS P6235cdn: Select the [Menu] ― key > [Adjust/Maint.] > [Service Setting] > [MC] and increase the adjustment value. Increase the adjustment value 1 level at a time from the current value. If there is no improvement after the value is increased by 1 level, increase by 1 level again. If there is still no improvement, return the setting to the original value. Select the [Menu] key > [Adjust/Maint.] ― > [Service Setting] > [Altitude Adj.], and set to an elevation one level higher than the current setting. The altitude is 1000 m or ― higher and dots appear in the image. Select the [Menu] key > [Adjust/Maint.] ― > [Service Setting] > [Altitude Adj.], and set to an elevation one level higher than the current setting. 10-10