Lantronix XPort APS: Modbus Protocol User Guide - Page 22

5: WiPort and WiBox Implementation CP0 Function (hit space to toggle) RS485 Select CP1 Function (hit space to toggle) RS485 2-Wire CP2 Function (hit space to toggle) GPIO (In) CP3 Function (hit space to toggle) GPIO (In) CP4 Function (hit space to toggle) GPIO (In) CP5 Function (hit space to toggle) Diag LED CP6 Function (hit space to toggle) Status LED-G CP7 Function (hit space to toggle) Status LED-Y CP8 Function (hit space to toggle) GPIO (In) CP9 Function (hit space to toggle) GPIO (In) CP10 Function (hit space to toggle) GPIO (Out) Invert (active low) (Y) ? Invert (active low) (Y) ? Invert (active low) (N) ? Invert (active low) (N) ? Invert (active low) (N) ? Invert (active low) (N) ? Invert (active low) (N) ? Invert (active low) (N) ? Invert (active low) (N) ? Invert (active low) (N) ? Invert (active low) (N) ? After all the configurable pins have been assigned, the standard modem control settings can be entered if applicable. RTS/CTS Mode (1=Fixed 2=Variable) (1) ? The setting for each configurable pin is displayed in the setup menu. Modbus/TCP to RTU Bridge Setup 1) Network/IP Settings: Network mode Wired Only IP Address 0.0.0.0/DHCP/BOOTP/AutoIP Default Gateway not set --- Netmask not set --- 2) Serial & Mode Settings: Protocol Modbus/RTU,Slave(s) attached Serial Interface 9600,8,N,1,RS232,CH1 3) Modem/Configurable Pin Settings: CP0..!RS485 Select CP1..!RS485 2-Wire CP2.. GPIO (In) CP3.. GPIO (In) CP4.. GPIO (In) CP5..!Diag LED CP6..!Status LED-G CP7..!Status LED-Y CP8.. GPIO (In) CP9.. GPIO (In) CP10. GPIO (Out) RTS Output Fixed High/Active 4) Advanced Modbus Protocol settings: Slave Addr/Unit Id Source .. fixed to 136 Modbus Serial Broadcasts ... Disabled (Id=0 auto-mapped to 1) MB/TCP Exception Codes ..... Yes (return 00AH and 00BH) Char, Message Timeout ...... 00050msec, 05000msec 6) WLAN Settings: WLAN Disabled, network:MSYS Topology Infrastructure, Country: US Security Authentication: PSK Encryption: TKIP TX Data rate 54 Mbps auto fallback Power management Disabled Soft AP Roaming Disabled WLAN Max failed packets .... 6 7) Security Settings: SNMP Enabled SNMP Community Name ........ public Telnet Setup Enabled TFTP Download Enabled Port 77FEh Enabled Web Server Enabled Web Setup Enabled Enhanced Password .......... Disabled Port 77F0h Enabled The menu option for WLAN Settings has been added to configure the WiFi parameters of the WiPort/WiBox. Modbus Protocol User Guide 22