Lenovo NetVista IBM PC300 (Type 2169) - Hardware Maintenance Manual (September - Page 78
BIOS Error Codes, Messages, and Beeps List, Hard Disk Drive Jumper Locations
View all Lenovo NetVista manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Table 2-1 BIOS Error Codes, Messages, and Beeps List BIOS Error Codes, Action/FRU Messages, beeps NOTE: To diagnose a problem, first find the BIOS error messages, codes, or beeps in left column. If directed to a check procedure, replace the FRU indicated in the check procedure. If no check procedure is indicated, the first Action/FRU listed in right column is the most likely cause. Memory test failure. Insert the memory modules in the DIMM sockets properly, and then reboot the system. Keyboard error or no keyboard present. Memory module. See the "Step 005" of "Memory" on page 95 to replace memory module. System board. Make sure the keyboard is connected properly and are set correctly in BIOS Setup. System board. FLOPPY DISK(S) failure (40) Floppy Type mismatch. Hard disk(s) Diagnosis failure Make sure the hard disks are set correctly in BIOS setup. Hard disk drive cable/connection. Hard disk drive. System board. Primary master hard disk failure Primary slave hard disk failure A warning message to indicate there has been change of IDE Primary (Secondary) Channel Master (Slave) device. Load default settings in Setup. Check IDE drive jumper. See "3.5-In. Hard Disk Drive Jumper Locations" on page 133. IDE drive power. IDE drive cable/connection. IDE drive. 76