Lenovo ThinkCentre A58 User Manual - Page 75
RAID signal cable
View all Lenovo ThinkCentre A58 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Diagnostic error code 030-027-XXX SCSI interface Configuration/Setup error 030-03X-XXX 030-04X-XXX SCSI interface error 030-195-XXX SCSI interface Test aborted by user 030-196-XXX SCSI interface test halt, error threshold exceeded 030-197-XXX SCSI interface test warning 030-198-XXX SCSI interface test aborted 030-199-XXX SCSI interface test failed, cause unknown 035-000-XXX RAID interface Test Passed 035-0XX-XXX RAID interface Failure 035-195-XXX RAID interface Test aborted by user FRU/Action 1. SCSI signal cable 2. Flash the system. See "Updating (flashing) BIOS from a disc" on page 278 3. SCSI device 4. SCSI adapter card, if installed 5. System board 1. SCSI signal cable 2. Check power supply 3. SCSI device 4. SCSI adapter card, if installed 5. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility program," on page 51 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility program," on page 51 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 278 3. Go to "Undetermined problems" on page 81 1. Go to "Undetermined problems" on page 81 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 278 3. Replace component under function test No action 1. RAID signal cable 2. RAID device 3. RAID adapter card, if installed 4. System board Information only Re-start the test, if necessary Chapter 7. Symptom-to-FRU index 69