Lenovo ThinkCentre Edge 72z Hardware Maintenance Manual (HMM) (May 2012) - Thi - Page 69
XX-XXX 005-3XX-XXX, 03X-XXX 011-04X-XXX
View all Lenovo ThinkCentre Edge 72z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Diagnostic Error Code FRU/Action 005-2XX-XXX 005-3XX-XXX Video subsystem error 1. Video card, if installed 2. System board 006-000-XXX Diskette interface Test Passed No action 006-0XX-XXX Diskette interface error 1. Diskette drive Cable 2. Diskette drive 3. System board 006-195-XXX Diskette interface Test aborted by user Information only Restart the test, if necessary 006-196-XXX Diskette interface test halt, error threshold exceeded 1. Press F3 to review the log file. 2. Restart the test to reset the log file. 006-197-XXX Diskette interface test warning 1. If a component is called out, make sure it is connected and/or enabled. 2. Re-run test. 3. Replace the component that is called out in warning statement. 4. Replace the component under test. 006-198-XXX Diskette interface test aborted 1. If a component is called out, make sure it is connected and/or enabled. 2. Flash the system and re-test. See "Flash update procedures" on page 127. 3. Go to "Undetermined problems" on page 78. 006-199-XXX Diskette interface test failed, cause unknown 1. Go to "Undetermined problems" on page 78. 2. Flash the system and re-test. 3. Replace component under function test. 006-25X-XXX Diskette interface Error 1. Diskette drive cable 2. Diskette drive 3. System board 011-000-XXX Serial port Interface Test Passed No action 011-001-XXX Serial port Presence 1. Remove external serial device, if present. 2. Run the Setup Utility program, enable port. 3. System board 011-002-XXX 011-003-XXX Serial port Timeout/Parity error System board 011-013-XXX 011-014-XXX Serial port Control Signal/Loopback test failure System board 011-015-XXX Serial port External Loopback failure 1. Wrap plug 2. System board 011-027-XXX Serial port Configuration/Setup error 1. run the Setup Utility program, enable port 2. Flash the system. See "Flash update procedures" on page 127. 3. System board 011-03X-XXX 011-04X-XXX Serial port failure System board 011-195-XXX Serial port Test aborted by user Information only Restart the test, if necessary. Chapter 7. Symptom-to-FRU Index 63