Lenovo ThinkCentre M58 Hardware Maintenance Manual - Page 59
USB port Interface Test Passed, USB port External Loopback failure
View all Lenovo ThinkCentre M58 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Diagnostic Error Code 006-196-XXX Diskette interface test halt, error threshold exceeded 006-197-XXX Diskette interface test warning 006-198-XXX Diskette interface test aborted 006-199-XXX Diskette interface test failed, cause unknown 006-25X-XXX Diskette interface Error 015-000-XXX USB port Interface Test Passed 015-001-XXX USB port Presence 015-002-XXX USB port Timeout 015-015-XXX USB port External Loopback failure 015-027-XXX USB port Configuration/Setup error 015-032-XXX USB port Device Controller failure 015-034-XXX USB port buffer allocation failure 015-035-XXX USB port Reset condition detected 015-036-XXX USB port Register error 015-040-XXX USB port IRQ failure 015-195-XXX USB port Test aborted by user FRU/Action 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. If a component is called out, make sure it is connected and/or enabled 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 276 3. Go to "Undetermined problems" on page 66 1. Go to "Undetermined problems" on page 66 2. Flash the system and re-test 3. Replace component under function test 1. Diskette drive cable 2. Diskette drive 3. System board No action 1. Remove USB device(s) and re-test 2. System board 1. Remove USB device(s) and re-test 2. System board 1. Remove USB device(s) and re-test 2. System board 1. Flash the system. See "Updating (flashing) BIOS from a disc" on page 276 2. System board System board 1. Reboot the system 2. Flash the system and re-test. See "Updating (flashing) BIOS from a disc" on page 276 3. Run memory test 4. System board 1. Remove USB device(s) and re-test 2. System board System board 1. Run setup and check for conflicts 2. Flash the system. See "Updating (flashing) BIOS from a disc" on page 276 3. System board Information only Re-start the test, if necessary Chapter 7. Symptom-to-FRU index 53