Lexmark C772 Menus and Messages Guide - Page 14

Using printer menus Menu selection Card Stock Loading Custom Loading Purpose Values Properly handles card stock Duplex whether the job is a duplexed or single-sided job. Off* Properly handles preprinted Duplex custom paper whether the job is a duplexed or single-sided job. Off* Shown if Card Stock is supported in the specified input source. Shown if the custom type is supported in the specified input source. Custom Types This menu selection is used to define a name for each custom paper type. You can assign names using a utility such as MarkVision or from the operator panel. Menu selection Custom Type [x] Purpose Specifies the type of paper associated with each Custom Type available in the Paper Type menu. Values Paper* Card Stock Transparency Glossy Labels Vinyl Labels Envelope The custom type media must be supported in the input source you designate in order to assign a userdefined name. Once the name is assigned, the name (truncated to 24 characters) will be displayed instead of Custom Type x. Universal Setup This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up. Menu selection Units of Measure Portrait Width Portrait Height Feed Direction Purpose Values Determines the unit of measure Inches (US) used to enter the Universal Height and Width. Millimeters (non-US) Inches is the US default; Millimeters is the international default. Sets the portrait width of the universal media. Note: If the value set exceeds the maximum width, the printer will use the maximum value allowed in inches or millimeters. 3 inches to 48 inches in 0.01 inch increments 76 mm to 1219 mm in 1 mm increments Shows either inches or mm from Units of Measure setting; 8.5 inches is the US default, and 216 mm is the international default. Sets the portrait height of the universal media. Note: If the value set exceeds the maximum height, the printer will use the maximum value allowed in inches or millimeters. 3 inches to 48 inches in 0.01 inch increments 76 mm to 1219 in 1mm increments Shows either inches or mm from the Units of Measure setting; 14 inches is the US default, and 356 mm is the international default. Specifies the feed direction of the Universal Paper Size. Short Edge* Long Edge Long Edge is only shown if the longest edge is shorter than the Maximum Physical Width of the printer. 14