Lexmark C772 Menus and Messages Guide - Page 52
Reading USB drive DO NOT REMOVE, Port disabled Remove USB drive
![]() |
View all Lexmark C772 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Understanding printer messages Message Action No jobs found Retry? Note: The four-digit personal identification number (PIN) you entered is not associated with any confidential print job. • Select Retry to enter another PIN. • Select Cancel to exit the Enter PIN screen. No jobs to cancel Wait for the message to clear. No recognized file types Wait for the message to clear. Note: The only supported file type is PDF. Not ready The printer is offline. Press to return to normal operation. Overflow Bin Full • The mailbox's designated overflow bin is full. • Remove the stack of paper from the bin to clear the message. Parallel A parallel interface is the active communication link. Port disabled Remove USB drive Wait for the message to clear. Power Saver • Send a job to print. • Press to warm the printer to normal operating temperature and display the Ready message. Printer locked, enter PIN to unlock The operator panel has been locked. Enter the correct PIN number. Printing Wait for the message to clear. Printing from USB drive DO NOT REMOVE Warning: Do not turn the printer off or remove the USB drive while this message is displayed. Wait for the message to clear. Printer busy Continue Quit Press to read the information from the USB drive. Select Quit to cancel the information retrieval process. Programming System Code DO NOT POWER OFF Warning: Do not turn the printer off while this message is displayed. Wait for the message to clear and the printer to reset. Programming Flash DO NOT POWER OFF Warning: Do not turn the printer off while this message is displayed. Wait for the message to clear. Programming Disk DO NOT POWER OFF Warning: Do not turn the printer off while this message is displayed. Wait for the message to clear. Reading USB drive DO NOT REMOVE Wait for the message to clear. Ready Send a job to print. Reattach The specified device is either not fully connected to the printer or is experiencing a hardware failure. • Reestablish communication by removing the specified device and reattaching it to the printer. • Press to clear the message and continue printing without using the device. • In the case of a hardware failure, turn the printer off and back on. If the error recurs, turn the printer off, remove the specified device, and call for service. Remote Management Active DO NOT POWER OFF The printer settings are being configured, and the printer was taken offline to ensure it is not currently printing and processing jobs. Wait for the message to clear. 52
![](/manual_guide/products/lexmark-772dn-menus-messages-guide-fabbe4a/52.png)