Lexmark C772 Menus and Messages Guide - Page 20

Using printer menus Menu selection Power Saver Purpose Values Specifies the amount of time (in minutes) the printer waits after a job is printed before it goes into a reduced power state. 1-240 Alarms Disabled Controls whether the printer sounds an alarm when the printer requires operator intervention. Alarm Control: Off Single* Continuous Cartridge Alarm: Off Single* Continuous Staple Alarm: Off* Single Continuous Specifies the amount of time after a print job before the printer goes into Power Saver mode. (Your printer may not support the entire range of values.) The factory default Power Saver setting depends on your printer model. Print the menu settings page to determine the current Power Saver setting. When the printer is in Power Saver mode, it is still ready to receive print jobs. Select 1 to put the printer in Power Saver mode one minute after it finishes a print job. This uses much less energy, but requires more warmup time for the printer. Select 1 if your printer shares an electrical circuit with room lighting and you notice lights flickering. Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum warm-up time. Select a value between 1 and 240 minutes if you want a balance between energy consumption and a shorter warm-up period. The value "Disabled" will be hidden if Energy Conserve (Config Menu) is set to On. Off-Printer does not sound an alarm. Single*-Printer sounds three quick beeps. Continuous-Printer repeats three beeps every 10 seconds. Note: Staple Alarm is only displayed when the finisher is installed. 20