Lexmark E450DN Service Manual - Page 69
Printhead assembly electronic adjustment on, The printhead
View all Lexmark E450DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
4512-630 7. If the grid lines of the right flap align below the corresponding lines on the left flap, adjust the printhead clockwise relative to the printer and recheck. (See the left side of the figure below.) If the grid lines of the left flap align below the corresponding lines of the right side, adjust the printhead counterclockwise. (See the right side of the figure below.) 8. After obtaining a properly adjusted image on the paper, tighten all three screws. Note: The printhead must be aligned electronically. See "Printhead assembly electronic adjustment" on page 3-6. Diagnostic aids 3-11
Diagnostic aids
3-11
4512-630
7.
If the grid lines of the right flap align below the corresponding lines on the left flap, adjust the printhead
clockwise relative to the printer and recheck. (See the left side of the figure below.) If the grid lines of the
left flap align below the corresponding lines of the right side, adjust the printhead counterclockwise. (See
the right side of the figure below.)
8.
After obtaining a properly adjusted image on the paper, tighten all three screws.
Note:
The printhead
must
be aligned electronically. See
“Printhead assembly electronic adjustment” on
page 3-6
.