Linksys QuickVPN Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN A - Page 127

Setting Up and Configuring the WRVS4400N Wireless-N Router Configuring the QoS Settings 5 Managing Bandwidth The QoS > Bandwidth Management window displays the settings for configuring bandwidth management for the router. To configure the bandwidth management settings, follow these steps: STEP 1 Click QoS > Bandwidth Management. STEP 2 Configure bandwidth management settings: • Bandwidth Specify the maximum bandwidth provided by the ISP on the WAN interface, for both the upstream and downstream directions. • Type The desired type of bandwidth management, either Rate Control (default) or Priority. Depending on your selection, the lower portion of the window displays either the Rate Control section or the Priority section. • Rate Control - Service-Select the service from the drop-down menu. If this menu does not contain the service you need, click Service Management to add the service. - IP-Enter the IP address or IP range you need to control. The default is 0 which includes all internal IP addresses. - Direction-Select Upstream for outbound traffic or Downstream for inbound traffic. - Min. Rate-Enter the minimum rate for the guaranteed bandwidth. - Max. Rate-Enter the maximum rate for the guaranteed bandwidth. - Enable-Check this box to enable this rate control rule. - Add to list-After a rule is set up, click this button to add it to the list. The list can contain a maximum of 15 entries. - Delete selected application-Click this button to delete a rule from the list. Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 127