Maytag MEDB800VQ Use and Care Guide - Page 11
Connect the other wires to outer terminal block screws. Tighten screws.
UPC - 883049140506
View all Maytag MEDB800VQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
4-wire connection: Power supply cord IMPORTANT: A 4-wire connection is required not permit the use of 3-wire connections. for mobile homes and where F local codes do 3. Connect ground wire (green or bare) of power supply cord to external ground conductor screw. Tighten screw. A A_ B CD E G A. 4-wire receptacle (NEMA type 14-30R) B. 4-prong plug C. Ground prong D. Neutral prong E. Spade terminals with upturned ends I] V4" ( 19 ram) UL listed strain relief C. Ring terminals 1° Remove center silver-colored terminal block screw. 2. Remove neutral ground wire from external ground conductor screw. Connect neutral ground wire and the neutral wire (white or center wire) of power supply cord under center, silver-colored terminal block screw. Tighten screw. B A C D A. fxtemal ground conductor B. Neutral ground wire screw C. Cround wire (green or bare) of power supply cord D. Y4" ( 19 ram) UL fisted strain refief E. Center silver-colored terminal bkJck screw I] Neutral wire (white or center wire) 4. Connect the other wires to outer terminal block screws. Tighten screws. II A. Neutral ground wire B. fxtema/ ground conductor screw - Dotted fine shows position of NLUTRAL ground wire before being moved to center silvercolored terminal block screw. C. Center silver-colored terminal block screw D. Neutral wire (white or center wire) E. Y4" ( 19 ram) UL fisted strain refief 5. Tighten strain relief screws. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold- down screw. 7. You have completed your electrical connection. Now go to "Venting Requirements."