Maytag MEDB800VQ Use and Care Guide - Page 9

Power Supply Cord I isl ¢;cA O ly Direct Wire Fire Hazard Use a new UL listed 30 amp power supply cord. Use a UL listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green ground connector. Connect remaining 2 supply wires to remaining 2 terminals (gold). Securely tighten all electrical connections. Failure to do so can result in death, fire, or electrical shock. 1. Disconnect power. 2. Remove the hold-down screw and terminal block cover. AB CD I A. Terminal block cover B. HoM-down screw location C. fxternal ground conductor screw D. Centel, si/ver-colored terminal block screw E. Neutral ground wire £ Hole below terminal opening block 3. Install strain relief. Fire Hazard Use 10 gauge sold copper wire. Use a UL listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green ground connector. Connect remaining 2 supply wires to remaining 2 terminals (gold}. Securely tighten all electrical connections. Failure to do so can result in death, fire, or electrical shock. Style 1: Power supply cord strain relief Remove the screws from a s/4" (1 9 mm) UI_ listed strain relief (UL marking on strain relief). Put the tabs of the two clamp sections into the hole below the terminal block opening so that one tab is pointing up and the other is pointing down, and hold in place. Tighten strain relief screws just enough to hold the two damp sections together. ; .;... i A V A. Strain refief tab pointing up B. Hole below terminal block opening C. Clamp section D. Strain relief tab pointing down 9