Maytag MMMF6030PZ Owners Manual - Page 11

5. Using a pencil to mark a upper cabinet hole. This step can be skipped if your unit is using recirculation or wall venting installation. NOTE: � If the front edge of the upper cabinet is lower than the back edge, lower the cardboard template so that its top is level with the front edge of the cabinet. A A. Upper Cabinet Hole Mark Rear Wall The microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum of 1 lag screw, preferably 2. See "Find the Wall Stud(s)" section for find the wall studs. 1. Using measuring tape, and find clearly mark the vertical centerline of the opening. D A C B A. Rear wall B. Cardboard plate C. Top of cardboard plate must align with front edge of cabinet D. Front edge of upper cabinet 3. Vertical the cardboard plate, holding the cardboard plate in place. Align the side center mark on the cardboard plate over the vertical centerline draw in step 1. Make sure the cardboard plate is level, and that the top of the cardboard template is butted up against the bottom edge of the upper cabinet. A A. Centerline 2. Align the center markers on the cardboard plate, to the centerline on the wall, making sure it is level, and that the top of the cardboard template is butted up against the back edge of the upper cabinet. Using a pencil to mark the wall venting hole (door wall venting installation only), skip it if your unit is for recirculation or wall venting installation. A B C A. Bottom Edge of Upper Cabinet & Top of the Cardboard Plate B. Side Center Marks on Cardboard Plate C. Centerline 4. Finding and drawing two small lines through the two cardboard plate bottom position lines. B A C A. Back Edge of Upper Cabinet B. Wall Venting Hole C. Cardboard Plate A A. Cardboard Plate Bottom Position Line 11