Maytag MMMF6030PZ Owners Manual - Page 8
Installation Types, Find the Cardboard Plate, Find the Wall Stud(s), Possible Wall Stud Configurations
View all Maytag MMMF6030PZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation Types This microwave oven is designed for adaptation to the following three types of ventilation, choose one type before installation. Recirculation (Factory Default Setting) Wall Venting Roof Venting Find the Cardboard Plate The cardboard plate is used as wall template and upper-cabinet template. It is located on the outer foam in the carton. Find it before installation. Find the Wall Stud(s) NOTE: If no wall studs exist within the cabinet opening, do not install the microwave oven. See illustrations in "Possible Wall Stud Configurations". 1. Using a stud finder, locate the edges of the wall stud(s) within the opening. 2. Mark the center of each stud, and draw a plumb line down each stud center. See illustrations in "Possible Wall Stud Configurations". Possible Wall Stud Configurations These depictions show examples of preferred installation configurations with the mounting plate. No Wall Studs at End Holes Figure 1 B No Wall Studs at End Holes Figure 2 B C A E F A. End holes (on mounting plate) B. Cabinet opening vertical centerline C. Wall stud centerlines C D A E D. Holes for lag screws E. Support tabs F. Mounting plate center markers C D A A E E F NOTE: If wall stud is within 6" (15.2 cm) of the vertical centerline, only recirculation or roof venting installation can be done. A. End holes (on mounting plate) B. Cabinet opening vertical centerline C. Wall stud centerlines D. Holes for lag screws E. Support tabs F. Mounting plate center markers 8