Maytag MMMF6030PZ Owners Manual - Page 17

Install Damper Assembly If for recirculation installation, no need to install the damper assembly, this section can be skip. And save it for future use. Install Damper Assembly for Wall Venting Installation 1. Check that damper blade moves freely and opens fully. 2. Position the damper assembly on the back of the microwave oven so that the damper blade hinge is at the top, and the damper blade opens away from the microwave oven. A B C D 3. Connect vent to damper assembly. A B A. Back of microwave oven B. Damper assembly C. Damper blade D. #6 x 3/8" Sheet metal screws 3. Secure damper assembly with two #6 x 3/8" sheet metal Install Damper Assembly for Roof Venting Installation 1. Check that damper blade moves freely and opens fully. 2. Insert damper assembly through the cabinet cutout so that the long tab of the damper assembly slides under the raised tabs of the damper plate. Then secure with #6 x 3/8" sheet metal screw. NOTE: The screw cannot be installed if the damper assembly is not positioned as shown. A B C A. Vent B. Damper assembly (under vent) Install the Microwave Oven WARNING Excessive Weight Hazard Use two or more people to move and install or uninstall appliance. Failure to do so can result in back or other injury. IMPORTANT: The control side of the microwave oven is the heavy side. Handle the microwave oven gently. 1. Place a washer on each 1/4-20 x 3" flat-head bolt and place inside upper cabinet near the 3/8" (10 mm) holes. 2. Make sure the microwave oven door is closed and taped shut. D E F A. Raised tabs B. Damper assembly C. #6 x 3/8" Sheet metal screws D. Upper cabinet cutout E. Long tab F. Damper plate 3. Using 2 or more people, lift microwave oven and hang it on support tabs at the bottom of mounting plate. NOTE: To avoid damage to the microwave oven, do not grip or use the door or while the microwave oven is being handled. A B A. Mounting plate B. Support tabs 17