Maytag MMMF6030PZ Owners Manual - Page 16
WARNING, Rotate Blower Motor for Roof Venting Installation
View all Maytag MMMF6030PZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
13. Secure damper plate with 2 screws removed in Step 1. A 3. Lower blower motor back into microwave oven. Exhaust ports face the top of microwave oven. A B A. Damper plate B. Screws WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 14. Plug in the microwave oven. Check if the vent fan runs with abnormal sounds, go back through the steps to see which step was skipped. Rotate Blower Motor for Roof Venting Installation 1. Repeat Steps 1 to 5 from "Wall Venting Installation Only". 2. Using diagonal wire cutting pliers, gently snip out the rectangular vent covers on the damper plate at the perforations. A A. Exhaust port IMPORTANT: If blower motor is not positioned with flat side facing the back of the microwave oven (as shown), performance will be poor. 4. Reconnect the blower motor wire into the connector. 5. Reattach the 2 blower screws into the recessed holes in the back of the microwave. 6. Check to make sure the 2 screws are secured properly in the blower motor screw holes, so that the motor cannot move. 7. Return the damper plate to its original horizontal position. A A. Damper plate 8. Secure damper plate with 2 screws removed in Step 1. A B A. Rectangular vent covers B. Diagonal wire cutting pliers B A. Damper plate B. Screws 9. Repeat Step 14 from "Wall Venting Installation Only". 16