Netgear GSM7224P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 445

ProSafe Managed Switch The last precedence applies to all non-TCP traffic. For example, in a 3-color system, four of each parameter specified: green TCP, yellow TCP, red TCP, and non-TCP, respectively. Format Modes random-detect queue-parms queue-id-1 [queue-id-2 ... queue-id-n] minthresh thresh-prec-1 ... thresh-prec-n max-thresh thresh-prec-1 ... threshprec-n drop-probability prob-prec-1 ... prob-prec-n • Global Config • Interface Config no random-detect queue-parms Use this command to set the WRED configuration back to the default. Format Modes no random-detect queue-parms queue-id-1 [queue-id-2 ... queue-id-n] • Global Config • Interface Config traffic-shape This command specifies the maximum transmission bandwidth limit for the interface as a whole. Also known as rate shaping, traffic shaping has the effect of smoothing temporary traffic bursts over time so that the transmitted traffic rate is bounded. Format Modes traffic-shape • Global Config • Interface Config no traffic-shape This command restores the interface shaping rate to the default value. Format Modes no traffic-shape • Global Config • Interface Config show classofservice dot1p-mapping This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a specific interface. The parameter is optional and is only valid on platforms that support independent per-port class of service mappings. If specified, the 802.1p mapping table of the interface is displayed. If omitted, the most recent global configuration settings are displayed. For more information, see Voice VLAN Commands on page 79. Format Mode show classofservice dot1p-mapping [] Privileged EXEC Quality of Service (QoS) Commands 445