Netgear GSM7224P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 593

ProSafe Managed Switch the switch's network interface do not affect the configuration of the front panel ports through which traffic is switched or routed. The network interface is always considered to be up, whether or not any member ports are up; therefore, the show network command will always show "Interface Status" as "Up". Format Modes show network • Privileged EXEC • User EXEC Term Definition Interface Status The network interface status; it is always considered to be "up". IP Address The IP address of the interface. The factory default value is 0.0.0.0. Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0. Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0. IPv6 Administrative Whether enabled or disabled. Mode IPv6 Address/Length The IPv6 address and length. IPv6 Default Router The IPv6 default router address. Burned In MAC Address The burned in MAC address used for in-band connectivity. Locally Administered MAC Address If desired, a locally administered MAC address can be configured for in-band connectivity. To take effect, 'MAC Address Type' must be set to 'Locally Administered'. Enter the address as twelve hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. The MAC address used by this bridge when it must be referred to in a unique fashion. It is recommended that this be the numerically smallest MAC address of all ports that belong to this bridge. However it is only required to be unique. When concatenated with dot1dStpPriority a unique BridgeIdentifier is formed which is used in the Spanning Tree Protocol. MAC Address Type The MAC address which should be used for in-band connectivity. The choices are the burned in or the Locally Administered address. The factory default is to use the burned in MAC address. The following shows example CLI display output for the network port. (Netgear Switch) #show network Interface Status Always Up IP Address 10.250.3.1 Subnet Mask 255.255.255.0 Default Gateway 10.250.3.3 IPv6 Administrative Mode Enabled IPv6 Address/Length is FE80::210:18FF:FE82:337/64 IPv6 Address/Length is 3099::1/64 IPv6 Address/Length is 3099::210:18FF:FE82:337/64 Management Commands 593