Netgear GSM7224P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 53

ProSafe Managed Switch If you specify port-priority, this command sets the priority for this port within a specific multiple spanning tree instance or the common and internal spanning tree instance, depending on the parameter, to the default value. Format Mode no spanning-tree mst Interface Config spanning-tree mst instance This command adds a multiple spanning tree instance to the switch. The parameter is a number within a range of 1 to 4094, that corresponds to the new instance ID to be added. The maximum number of multiple instances supported by the switch is 4. Default Format Mode none spanning-tree mst instance Global Config no spanning-tree mst instance This command removes a multiple spanning tree instance from the switch and reallocates all VLANs allocated to the deleted instance to the common and internal spanning tree. The parameter is a number that corresponds to the desired existing multiple spanning tree instance to be removed. Format Mode no spanning-tree mst instance Global Config spanning-tree mst priority This command sets the bridge priority for a specific multiple spanning tree instance. The parameter is a number that corresponds to the desired existing multiple spanning tree instance. The priority value is a number within a range of 0 to 61440 in increments of 4096. If you specify 0 (defined as the default CIST ID) as the , this command sets the Bridge Priority parameter to a new value for the common and internal spanning tree. The bridge priority value is a number within a range of 0 to 61440. The twelve least significant bits are masked according to the 802.1s specification. This causes the priority to be rounded down to the next lower valid priority. Default Format Mode 32768 spanning-tree mst priority Global Config Switching Commands 53