Netgear GSM7224P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 641

ProSafe Managed Switch Note: To re-configure a RADIUS authentication server to use the default UDP , set the parameter to 1812. If you use the token, the command configures the IP address or hostname to use for the RADIUS accounting server. You can only configure one accounting server. If an accounting server is currently configured, use the "no" form of the command to remove it from the configuration. The IP address or hostname you specify must match that of a previously configured accounting server. If you use the optional parameter, the command configures the UDP port to use when connecting to the RADIUS accounting server. If a is already configured for the accounting server, the new replaces the previously configured . The must be a value in the range 0 - 65535, with 1813 being the default. Note: To re-configure a RADIUS accounting server to use the default UDP , set the parameter to 1813. Format Mode radius server host {auth | acct} {} [name ] [port ][server-type] Global Config Field ipaddr dnsname 0-65535 servername Description The IP address of the server. The DNS name of the server. The port number to use to connect to the specified RADIUS server. The alias name to identify the server. no radius server host Use the no version of this command to delete the configured server entry from the list of configured RADIUS servers. If the RADIUS authenticating server being removed is the active server in the servers that are identified by the same server name, then the RADIUS client selects another server for making RADIUS transactions. If the 'auth' token is used, the previously configured RADIUS authentication server is removed from the configuration. Similarly, if the 'acct' token is used, the previously configured RADIUS accounting server is removed from the configuration. The parameter must match the IP Management Commands 641