Netgear GSM7224P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 452

ProSafe Managed Switch no match class-map This command removes from the specified class definition the set of match conditions defined for another class. The is the name of an existing DiffServ class whose match conditions are being referenced by the specified class definition. Format Mode no match class-map Class-Map Config Ipv6-Class-Map Config match cos This command adds to the specified class definition a match condition for the Class of Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN tagged packet). The value may be from 0 to 7. Default Format Mode none match cos Class-Map Config Ipv6-Class-Map Config match secondary cos This command adds to the specified class definition a match condition for the secondary Class of Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN tagged packet). The value may be from 0 to 7. Default Format Mode none match secondary-cos Class-Map Config match ip6flowlbl This command adds to the specified class definition a match condition based on the IP6flowlbl of a packet. The label is the value to match in the Flow Label field of the IPv6 header (range 0-1048575). Format Mode match ip6flowlbl Ipv6-Class-Map Configuration mode match destination-address mac This command adds to the specified class definition a match condition based on the destination MAC address of a packet. The parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers separated by colons (e.g., Quality of Service (QoS) Commands 452