Oki OKIPAGE10i Users' Guide for the OKIPAGE10i - Page 51

Hardware Problems

Get Oki OKIPAGE10i PDF manuals and user guides View all Oki OKIPAGE10i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

Hardware Problems Symptom: Problem: Solution: Graphic image prints partly on one page, partly on the next. Insufficient printer memory for this image at this resolution. Change the resolution, reduce the image size, or install more memory in your printer. Symptom: Problem: Solution: Nothing happens, but printer indicates it is ready to receive data. Configuration error. Check cable connection; if serial, make sure appropriate MODE command has been used (PC). If more than one printer is available, make sure your printer has been selected. Make sure your printer is on-line. Symptom: Problem: Solution: Symptom: Problem: Solution: "Garbage" prints. Incorrect cable configuration. (Also, see "Software Problems.") Check cable configuration, continuity, and length. Printer freezes or displays error message when computer is rebooted. Booting the computer while the printer is on can cause a communications error. Take printer off-line before rebooting computer. Problem: Solution: Gases are given off by forms or adhesives passing through the hot fusing unit. Make sure the forms you use can withstand heating, and provide adequate ventilation. OKIPAGE 10i User's Guide 4 Problem Solving 41 °

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
OKIPAGE
10i
User’s Guide
41
4
Problem Solving
Hardware Problems
Symptom:
Graphic image prints partly on one page, partly on the
next.
Problem:
Insufficient printer memory for this image at this
resolution.
Solution:
Change the resolution, reduce the image size, or install
more memory in your printer.
Symptom:
Nothing happens, but printer indicates it is ready to
receive data.
Problem:
Configuration error.
Solution:
Check cable connection; if serial, make sure appropriate
MODE command has been used (PC). If more than one
printer is available, make sure your printer has been
selected. Make sure your printer is on-line.
Symptom:
“Garbage” prints.
Problem:
Incorrect cable configuration. (Also, see “Software
Problems.”)
Solution:
Check cable configuration, continuity, and length.
Symptom:
Printer freezes or displays error message when computer
is rebooted.
Problem:
Booting the computer while the printer is on can cause a
communications error.
Solution:
Take printer off-line before rebooting computer.
Problem:
Gases are given off by forms or adhesives passing
through the hot fusing unit.
Solution:
Make sure the forms you use can withstand heating, and
provide adequate ventilation.