Olympus C-7070 Zoom C-7070 Instruction Manual - Page 177

Troubleshooting Possible cause Corrective action Ref. page The monitor does not turn on. [MONITOR] is set to Press f several times, and turn on the [OFF]. monitor. P. 30 The viewfinder or monitor is hard to see. The diopter is not adjusted properly. Adjust the diopter so that the AF target mark P. 29 is clearly visible. There is condensation* inside the camera. The brightness of the monitor is not adjusted properly. Turn the camera off and wait until it dries before turning it on again. Select [s] in [MODE MENU] and adjust the brightness. - P. 130 The monitor is exposed Block the sunlight with your hand or use the - to direct sunlight. viewfinder. Vertical lines appear on Aiming the camera at a bright subject in - the monitor screen sunlight may cause vertical lines to appear during shooting. on the screen. This is not a malfunction. The date recorded with the image data is wrong. The date/time is not set. Set the date/time. The clock adjustment is not factory-preset. P. 123 The camera has been left with the battery removed. If the camera is left for 3 days with the battery P. 123 removed, the date/time setting is canceled. Set the date/time again. The settings are returned to the factory default settings when the camera is turned off. [ALL RESET] is set to [ON]. Set [ALL RESET] to [OFF] in [MODE MENU]. P. 120 The picture is out of focus. The subject was too close. Move further away from the subject. To take pictures closer than 20 cm (7.9") with the zoom in the maximum WIDE position, use the super macro mode. P. 46 The subject is dark. Set [AF ILLUMINATOR] to [ON] in the mode P. 66 menu. Auto focus is not Use manual focus or focus lock to focus on P. 31, possible. the subject and then shoot. There is condensation* Turn the camera off and wait until it dries 66 - 10 on the lens. before turning it on again. Appendix 177