Olympus D-490 D-490 Zoom Instruction Manual (2.6 MB) - Page 21

Taking Still Photos

Page 21 highlights

Taking Still Photos Taking Photos Using the Viewfinder Half-press 1 2 1 Compose the photo inside the viewfinder. Viewfinder 2 Press the shutter release button halfway down until the green lamp next to the viewfinder lights up (half-press). • The focus and exposure are automatically set. • If the green lamp blinks, the camera is out of focus. Take your finger off the shutter release button and half-press it again. Autofocus mark Shutter release button § Go on to "Taking Pictures" on the following page. Green lamp 40 Taking Pictures Full-press 1,2 1 Press the shutter release button all the way down (full-press). • Press the shutter release button gently. If you press it too hard, the camera will move and blur the shot. • The shot is taken and the camera beeps. • The green lamp next to viewfinder blinks for a few 2 moments, and it goes off. Learning the Basics 2 To take another picture, compose the shot and Shutter release button full-press the shutter release button. • If you attempt to take a picture before the green lamp goes off, the camera does not beep but you still cannot take the picture. Wait for a few seconds and make sure the green lamp goes off before taking another shot. • To turn the power off, see "Turning the Power Off" (p.47). CAUTION • Never open the card compartment cover, remove the batteries or card, or disconnect the AC adapter while the green lamp and write mark are blinking. This could damage the pictures you have already taken, as well as the one currently being written to the card. HELP • The area of the actual photo will be slightly larger than the shot appears through the viewfinder. • If the write mark is blinking, this indicates that the image is being processed. You cannot depress the shutter release button while the write mark is blinking. • If you switch the beep function off (p.98), the camera will not beep after taking a picture. In this case you must watch the green lamp. If the lamp blinks, the picture was taken successfully. 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73

Taking Pictures
Full-press
1
Press the shutter release
button all the way down
(full-press).
Press the shutter release
button gently. If you press it
too hard, the camera will
move and blur the shot.
The shot is taken and the
camera beeps.
The green lamp next to
viewfinder blinks for a few
moments, and it goes off.
2
To take another picture,
compose the shot and
full-press the shutter release
button.
If you attempt to take a picture
before the green lamp goes
off, the camera does not beep
but you still cannot take the
picture. Wait for a few seconds
and make sure the green
lamp goes off before taking
another shot.
To turn the power off, see
“Turning the Power Off” (p.47).
CAUTION
Never open the card compartment cover, remove the batteries or card, or
disconnect the AC adapter while the green lamp and write mark are
blinking. This could damage the pictures you have already taken, as well
as the one currently being written to the card.
HELP
The area of the actual photo will be slightly larger than the shot appears
through the viewfinder.
If the write mark is blinking, this indicates that the image is being
processed.You cannot depress the shutter release button while the write
mark is blinking.
If you switch the beep function off (p.98), the camera will not beep after
taking a picture. In this case you must watch the green lamp. If the lamp
blinks, the picture was taken successfully.
2
Learning the Basics
Taking Still Photos
Taking Photos Using the Viewfinder
Half-press
1
Compose the photo inside
the viewfinder.
2
Press the shutter release
button halfway down until the
green lamp next to the
viewfinder lights up
(half-press).
The focus and exposure are
automatically set.
If the green lamp blinks, the
camera is out of focus.Take
your finger off the shutter
release button and half-press
it again.
Go on to “Taking Pictures” on
the following page.
40
1
2
Viewfinder
Autofocus
mark
Green lamp
1,2
Shutter
release
button
Shutter
release
button
41