Olympus D-490 D-490 Zoom Instruction Manual (2.6 MB) - Page 25

Chapter 3 Playing Images Back Getting Started Turning the Power On in the Playback Mode 1 Make sure the lens barrier is closed. 2 Press the monitor button. 1 2 • The camera turns on in playback mode and the monitor displays the last image taken. • "NO PICTURE" is displayed on the monitor if no pictures have been taken. Any problems with the card are indicated on the monitor (p.55). • The battery check mark blinks when the batteries are running low. Standby mode If the camera is left untouched for three minutes when using the batteries, it automatically turns off. It is strongly recommended, however, that you switch power off promptly when you are finished using the camera. When using new batteries, it may take longer for the camera to shut down automatically depending on the type of batteries being used. CAUTION • Never open the card compartment cover, remove the batteries or card, or disconnect the AC adapter while the camera is in operation as this could result in damage to the data stored on the card. • Do not press on the monitor as this could leave a mark on the screen, interfere with image display, or even crack the monitor. 48 HELP • After turning the power on, the monitor may flash and display an image after 0.5 to 2 seconds. This is not a malfunction. Turning the Power Off in Playback Mode 1 Press the monitor button. • The monitor display shuts 1 down and the power turns off. 3 Playing Images Back 49