Onkyo TX-8270 Owners Manual - English/Spanish/French - Page 10
Step2, Connect the Speakers
View all Onkyo TX-8270 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
> Before Start > Part Names > Install > Initial Setup > Playback Advanced Setup | Supplementary Information | Others Step2: Connect the Speakers 1/2˝ (12 mm) Up to two powered subwoofers can be connected. The same signal is output from each of the SUBWOOFER PRE OUT jacks. When connecting another set of front speakers to use as the Speakers B System, connect them to the SPEAKERS B terminals. Connect using the same method described for SPEAKERS A. Note that when connecting to both SPEAKERS A and B terminals, connect speakers with 8 ≠ to 16 ≠ impedance to both A and B. Setup 0 If a powered subwoofer is not connected, then after Initial Setup is complete, settings are required in the Setup menu. Press SETUP on the remote controller, select "2. Speaker" "Configuration" and set "Subwoofer" to "No". 0 If any of the connected speakers have an impedance of 4 ≠ or more to less than 6 ≠, or when a Speaker B system is to be used, after completing Initial Setup, you need to make some settings in the Setup menu. Press SETUP on the remote controller, select "2. Speaker" - "Configuration" and set "Speaker Impedance" to "4ohms". b a a Speaker cable, b Subwoofer cable 10 Speaker B Connect the speaker cable so the wires do not protrude from the speaker jacks. If the exposed wires of the speakers touch the rear panel or the + and - wires touch each other, the protection circuit will be activated.