Onkyo TX-8270 Owners Manual - English/Spanish/French - Page 38
Audio Adjust, Source
View all Onkyo TX-8270 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
> Before Start > Part Names > Install > Initial Setup > Playback Advanced Setup | Supplementary Information | Others 0 This setting cannot be selected when you have set "Configuration" - "Subwoofer" to "No". ∫ 3. Distance Set the distance from each speaker to the listening position. Front Left Front Right Subwoofer Specify the distance between each speaker and the listening position. (Default Value is "12.0 ft/3.60 m") Specify the distance between each speaker and the listening position. (Default Value is "12.0 ft/3.60 m") Specify the distance between each speaker and the listening position. (Default Value is "12.0 ft/3.60 m") 0 Default values vary depending on the regions. 0 Distance units can be switched by pressing CAPS on the remote controller. When the unit is set as feet, you can set between 0.1 ft and 30.0 ft in increments of 0.1 ft. When the unit is set as meters, you can set between 0.03 m and 9.00 m in increments of 0.03 m. ∫ 4. Level Calibration Front Left Front Right Subwoofer Select a value between "-12.0 dB" and "+12.0 dB" (in 0.5 dB increments). A test tone will be output each time you change the value. Select the desired level. (Default Value is "0.0 dB") Select a value between "-12.0 dB" and "+12.0 dB" (in 0.5 dB increments). A test tone will be output each time you change the value. Select the desired level. (Default Value is "0.0 dB") Select a value between "-15.0 dB" and "+12.0 dB" (in 0.5 dB increments). A test tone will be output each time you change the value. Select the desired level. (Default Value is "0.0 dB") Maximum Volume Power On Volume Headphone Level Set the maximum value to avoid too high volume. Select "Off (default value)" or a value between "50" to "99". Set the volume level of when the power is turned on. Select "Last (default value)" (volume level before entering standby mode), "Min", "0.5" to "99.5" and "Max". 0 You cannot set a higher value than that of "Maximum Volume". Adjust the output level of the headphones. Select from "12.0 dB" to "+12.0 dB". (Default Value is "0.0 dB") 4. Source ∫ 1. IntelliVolume Adjust the volume level difference between the devices connected to the unit. Select the input selector to configure. IntelliVolume Select from "-12.0 dB" to "+12.0 dB". Set a negative (j) value if the volume of the target device is larger than the others and a positive (i) value if smaller. To check the audio, start playback of the connected device. (Default Value is "0.0 dB") 0 This function is not effective in ZONE 2. ∫ 2. Name Edit Set an easy name to each input. The set name will be shown on the main unit display. Select the input selector to configure. 3. Audio Adjust ∫ 1. Volume Mute Level Set the volume lowered from the listening volume when muting is on. Select a value from "-¶dB (default value)", "-40dB", and "20dB". 38