Onkyo TX-8270 Owners Manual - English/Spanish/French - Page 41

> Before Start > Part Names > Install > Initial Setup > Playback Advanced Setup | Supplementary Information | Others Audio TV Out Audio Return Channel Auto Lip Sync You can enjoy audio through the speakers of the TV while this unit is on. "On": When this function is to be used "Off (default value)": When this function is not to be used 0 The setting is fixed to "Auto" if "HDMI CEC" is set to "On". If you change this setting, set "HDMI CEC" to "Off" 0 Depending on your TV set or input signal of the component, audio may not output through the speakers of the TV even if this setting is set to "On". In such case, audio is output from the speakers of the unit. 0 If you operate the volume dial on this unit when audio that is being input through this unit for output from the TV speakers, audio is output from this unit. If you do not want to output audio from the unit, change the unit or TV settings, or reduce the volume of the unit. You can enjoy sound of the HDMI connected ARC compatible TV through the speakers connected to the unit. To use this function, set "HDMI CEC" to "On" in advance. "Auto": To enjoy the TV sound through the speakers connected to this unit "Off": When not using the ARC function This setting automatically corrects any desynchronization between the video and audio signals based on data from the HDMI LipSync compatible TV. "On (default value)": Automatic correction will be enabled. "Off": Automatic correction will be disabled. ∫ 2. Network 0 When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the setting automatically. Further, to assign fixed IP addresses to each component, you must set "DHCP" to "Disable" and assign an address to this unit in "IP Address" as well as set information related to your LAN, such as Subnet Mask and Gateway. Wi-Fi Connect the unit to network via wireless LAN router. "On": Wireless LAN connection "Off (Wired) (default value)": To connect via wired LAN Wi-Fi Setup Wi-Fi Status MAC Address DHCP IP Address Subnet Mask Gateway DNS Server Proxy URL Proxy Port You can configure wireless LAN settings by pressing ENTER when "Start" is displayed. 0 Refer to "2. Network Connection" (P17) in Initial Setup for Wi- Fi settings. The information for the connected access point is displayed. "SSID": The SSID of the connected access point "Signal": The signal strength of the connected access point "Status": The status of the connected access point This is the MAC address of the AV receiver. This value is specific to the component and cannot be changed. "Enable (default value)": Auto configuration by DHCP "Disable": Manual configuration without DHCP If "Disable" is selected, you must set "IP Address", "Subnet Mask", "Gateway", and "DNS Server" manually. Displays/Sets the IP address. Displays/Sets the subnet mask. Displays/Sets the gateway. Displays/Sets the primary DNS server. Displays/Sets the proxy server URL. Displays/Sets the proxy server port number when you enter "Proxy URL". En 41