Onkyo TX-SR602 Owner Manual - Page 38

59/3 @&OCPPL 1BHF  5VFTEBZ 4FQUFNCFS 1. Connecting the AV receiver-Continued Connecting the Power Cords of Other Components The AV receiver has AC outlets on its rear panel that can be used to connect the power cords of AV other components that you intend to use with the AV receiver. These components can then be left turned on so that they turn on and off as and when the AV receiver is turned on and set to Standby. Turning On the AV receiver • American & Australian models • Other models STANDBY/ON STANDBY/ON ON STANDBY AC OUTLETS AC 120V 60 Hz SWITCHED TOTAL 120W 1A MAX. AC OUTLETS AC 230-240V 50 Hz SWITCHED TOTAL 100W MAX. European and some Asian models American model Caution: • Make sure that the total capacity of the components that you connect to the AC OUTLETS does not exceed the stated capacity (e.g., TOTAL 120 W). Note: • Onkyo components with jacks should be con- nected directly to wall outlets, not the AV receiver's AC OUTLETS. • The number of AC OUTLETS, socket type, and total capacity depends on the country in which you purchased the AV receiver. Connecting the RS232 Port The TX-SR602/602E, TX-SR8260, American and Australian TX-SR702 do not have this port. This port can be used to connect an external controller for controlling the AV receiver. Connecting the Power Cord • Before connecting the power cord, connect all your speakers and AV components. • Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit. 38 1 POWER ON OFF 2 Remote controller ON POWER Set the [POWER] switch to the ON position ( ). (Skip this step if you have the American or Australian model.) The AV receiver enters Standby mode, and the STANDBY indicator comes on. Note: • The remote controller has no effect while the [POWER] switch in the OFF position. Press the [STANDBY/ON] button. Alternatively, press the remote controller's [RECEIVER] button followed by the [ON] button. The AV receiver comes on, the display lights up, and the STANDBY indicator goes off. STANDBY To turn off the AV receiver, press the [STANDBY/ON] button. The AV receiver will enter Standby mode. Notes: • Pressing the remote controller's [ON] button once will turn on the AV receiver. Pressing it again will turn on any components connected via . • When the AV receiver is on Standby, it will turn on automatically when any one of its input selector buttons is pressed. Not for the American and Australian models: • The AV receiver is shipped with the POWER switch in the ON position ( ). When the power cord is connected for the very first time, the AV receiver will go on Standby and the STANDBY indicator will light up. • To completely shut down the AV receiver, set the POWER switch to the OFF position ( ).