Onkyo TX-SR602 Owner Manual - Page 40

@4FUVQ@&O 1BHF  5VFTEBZ 4FQUFNCFS 1. First Time Setup-Continued 3 ENTER 4 ENTER 5 ENTER Press [ENTER]. Auto Speaker Setup Do not Unplug Setup Mic Wait a moment, Please. The automatic speaker setup starts. The test tone is output by each speaker in turn, measured by the microphone, and the speaker settings set accordingly. The whole process takes about 90 seconds. Auto Speaker Setup Do not Unplug Setup Mic Left Center Right Surr Right SurrBack R SurrBack L Surr Left Subwoofer If any extraneous noise is picked up by the microphone, the automatic setup may not work correctly, so be careful. When the Check Result menu appears, press [ENTER]. Auto Speaker Setup Push Enter:Check Results :Set The Setup Result menu appears. 0.Auto Sp Setup Result 1.Warning 2.Speaker Config 3.Distance 4.Level 1 Warning 2 Number of speakers and their sizes 3 Distance from each speaker to the listening position 4 The optimum volume level for each speaker Use the Up and Down [ ]/[ ] buttons to select the item that you want to check, and then press [ENTER]. ENTER 40 6 7 ENTER 8 Press the [RETURN] button to return to the previous menu. 0-1.Warning *1 Not Connect Too Near/Far Speaker 0-2.Speaker Config Subwoofer :Yes Front :Large Center :Small Surround :Small SurroundBack :Small SurrBack ch :2ch Crossover :100Hz *2 0-3.Distance Left : 3.6m Center : 3.6m Right : 3.6m Surr Right : 2.1m Surr Back R : 2.1m Surr Back L : 2.1m Surr Left : 2.1m Subwoofer : 3.6m 0-4.Level Left : 00dB Center : 00dB Right : 00dB Surr Right : 00dB Surr Back R : 00dB Surr Back L : 00dB Surr Left : 00dB Subwoofer : 00dB (Menus vary depending on country.) *1 When a speaker has a warning, its abbre- viation (e.g., L, R, and so on) appears instead of the "---" dashes. If you want to adjust any of the settings manually, see "Speaker Setup" on page 46. Note: *2 Please set any THX Certified speakers manually to 80 Hz after Auto setup operation (see page 46, 47). When you've checked the settings, press the [RETURN] button to return to the previous menu. Auto Speaker Setup Push Enter:Check Results :Set When you've finished the automatic setup, press the Right [ ] button. That completes the setup. To run the automatic setup again, press the Left [ ] button. The automatic speaker setup starts again. Disconnect the speaker setup microphone. To cancel the automatic setup while it's in progress, disconnect the microphone.