Onkyo TX-SR602 Owner Manual - Page 67

59/3 @&OCPPL 1BHF  5VFTEBZ 4FQUFNCFS 1. Advanced Operation-Continued AV Recording You can record AV input sources to an AV recording component (VCR, etc) connected to the VIDEO 1 OUT or VIDEO 2 OUT. See pages 27-38 for information on connecting components. 1 Recording Separate AV Sources Here you can record audio and video from completely separate sources, allowing you to overdub audio onto your video recordings. This function takes advantage of the fact that when an audio-only input source (i.e., TAPE, TUNER, or CD) is selected, the video input source remains unchanged. In the following example, audio from the CD player connected to the CD IN, and video from the camcorder connected to the VIDEO 4 INPUT VIDEO jack are recorded by the VCR connected to the VIDEO 1 OUT jacks. Camcorder 1 Use the input selector buttons to select the AV component that you want to record. Audio signals from the selected input source are output by the VIDEO 1 OUT and VIDEO 2 OUT only. You can watch the source while record- ing, and the AV receiver's VOLUME control has no effect on recording. video signal audio signal 2 Start recording on the AV compo- nent connected to the VIDEO 1 OUT or VIDEO 2 OUT. 3 Start playback on the source AV component. CD player VCR If you select another input source dur- ing recording, that input source will be recorded. 1 Prepare the camcorder and CD player for playback. 2 Prepare the VCR for recording. 3 Press the [VIDEO 4] input selector button. 4 Press the [CD] input selector button. This selects the CD player as the audio source, but leaves the camcorder as the video source. 5 Start recording on the VCR and start playback on the camcorder and CD player. The video from the camcorder and the audio from the CD player are recorded by the VCR. 67