Onkyo TX-SR602 Owner Manual - Page 78

59/3 @&OCPPL 1BHF  5VFTEBZ 4FQUFNCFS 1. Zone 2-Continued Using Zone 2 Here you can turn on Zone 2, select an input source, and adjust the volume. 1 4 2 1-4 3 Note: To control Zone 2 with the remote controller, you must press the [ZONE 2] button first. 1 ZONE 2 ON Point the remote controller at the AV receiver and press the [ZONE 2] button followed by the [ON] button. This turns on Zone 2 and the AV receiver's 12V TRIGGER OUT. 2 ZONE 2 To select the Zone 2 input source with the remote controller, press the [ZONE 2] button followed by an input selector button. If you select AM or FM, you can use the remote controller's [TUNER] button to select the band. To perform steps 1 and 2 on the AV receiver, press the [ZONE 2] button, and then use the Controller [ ]/[ ] buttons within five seconds. The name of the selected Zone 2 source appears on the display. To set Zone 2 to the same source as the main room, press the [ZONE 2] button, and then use the Controller [ ]/[ ] buttons to select "Zone 2 Sel: Source." 3 ZONE 2 To adjust the Zone 2 volume with the remote controller, press the [ZONE 2] button, and then use the [LEVEL-] and [LEVEL+] buttons. LEVEL- LEVEL+ To do this on the AV receiver, press the ZONE 2 [LEVEL] button, and then use the Controller [ ]/[ ] buttons. If the Zone 2 receiver/integrated amp is connected to the AV receiver's ZONE 2 LINE OUT L/R jacks, use the volume control on the receiver/integrated amp. 4 ZONE 2 To turn off Zone 2 with the remote controller, press the [ZONE 2] button followed by the [STANDBY] button. STANDBY To do this from the AV receiver, press the [ZONE 2] button, and then use the Controller [ ]/[ ] buttons to select OFF. Notes: • If the Sleep function has been set, the Zone 2 compo- nent will turn off along with the AV receiver when the specified sleep time expires. To use the Sleep function with Zone 2 only, set the Sleep function and then set the AV receiver to Standby. • Only analog input sources are output by the ZONE 2 LINE OUT and ZONE 2 SPEAKERS terminals. Digital input sources are not output. If no sound is heard when an input source is selected, check if it's connected to an analog input. • Since the Zone 2 function and the REC OUT outputs use the same circuitry, if the [REC OUT] function is used, Zone 2 will be turned off. • While Zone 2 is being used, listening modes that need surround back speakers (i.e., Dolby Digital EX, DTSES, and THX Surround EX) are unavailable. • While Zone 2 is on, functions will not work. • You can't select different radio stations for Zone 2 and the main room. For example, if you an FM station for the main room, that station will also be used in Zone 2. 78