Optoma WU1500 User manual - Page 13

SETUP AND INSTALLATION, Installing the projection lens

Get Optoma WU1500 PDF manuals and user guides View all Optoma WU1500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

SETUP AND INSTALLATION Installing the projection lens Before setting up the projector, install the projection lens on the projector. IMPORTANT! ‡‡ Make sure the projector is properly turned off before installing the lens. ‡‡ During lens installation, do not adjust the lens shift, zoom, or focus either using the remote control or the projector keypad. ‡‡ After any lens replacement, lens calibration is necessary; otherwise, it may cause damage to the lens and system. ‡‡ Ensure that the lens is at or near the central location when installing or removing. Installing or removing lens at a large offset may cause damage to the lens and system. Procedure: 1. Remove the lens cap from the projector. 2. Remove both lens caps (front and back) on the lens. 3. Align the red dot label on the lens with the red dot label on the lens mount. Then install the lens assembly into the lens mount. English 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
English
13
SETUP AND INSTALLATION
Installing the projection lens
Before setting up the projector, install the projection lens on the projector.
IMPORTANT°
±
Make sure the projector is properly turned off before installing the lens.
±
During lens installation, do not adjust the lens shift, zoom, or focus either using the remote control or
the projector keypad.
±
After any lens replacement, lens calibration is necessary; otherwise, it may cause damage to the lens
and system.
±
Ensure that the lens is at or near the central location when installing or removing. Installing or
removing lens at a large offset may cause damage to the lens and system.
Procedure:
1.
Remove the lens cap from the projector.
2.
Remove both lens caps (front and back) on the lens.
3.
Align the red dot label on the lens with the red dot label on the lens mount. Then install the lens
assembly into the lens mount.