Panasonic PT-AE1000U Hd Home Cinema Projector - Page 48
Inquiry commands, Basic format, Cable specifications, Projector, PC DTE
UPC - 791871111390
View all Panasonic PT-AE1000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Technical Information J Inquiry commands Command QPW QFZ QIN QOT QPM QSH QWM Control contents Parameter Power status 000 = OFF 001 = ON FREEZE status 0 = OFF 1 = ON Input signal status SLEEP status PICTURE MODE status Parameter: (page 23) SVD = S-VIDEO IN VID = VIDEO IN HD1 = HDMI1 IN RG1 = PC IN HD2 = HDMI2 IN CP1 = COMPONENT1 IN CP2 = COMPONENT2 IN 0 = OFF 1 = 60 min. 2 = 90 min. 3 = 120 min. 4 = 150 min. 5 = 180 min. 6 = 210 min. 7 = 240 min. (page 25) Parameter: (page 25) NAT = COLOR1 NOR = NORMAL DYN = DYNAMIC CN1 = CINEMA1 CN2 = CINEMA2 CN3 = CINEMA3 VID = COLOR2 SHUTTER status 0 = OFF 1 = ON WAVEFORM status Parameter: (page 24) 0 = OFF 1 = FULL SCAN (Y) 2 = FULL SCAN (R) 3 = FULL SCAN (G) 4 = FULL SCAN (B) 5 = SINGLE LINE SCAN (Y) 6 = SINGLE LINE SCAN (R) 7 = SINGLE LINE SCAN (G) 8 = SINGLE LINE SCAN (B) J Basic format STX Start byte (02h) Command : Parameter 3 bytes 1 byte 1 byte 4 bytes ETX End (03h) The data streaming from the computer will start with STX, and proceed to Command, Parameter and end with ETX. You can add the required parameter. The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds before sending the command. If sending multiple commands, check that a response has been received from the projector for one command before sending the next command. When a command which does not require parameters to be sent, the colon (:) is not required. If an incorrect command is sent from the personal computer, the ER401 command will be sent from the projector to the personal computer. J Cable specifications (When connected to a a personal computer) NC NC NC Projector NC NC PC (DTE) NC NC NC Appendix 48 - ENGLISH