Panasonic WJHD500A WJHD500A User Guide - Page 22
CONNECTION WITH THE DVD EXTENSION UNIT, Switch Settings, without HDD>
View all Panasonic WJHD500A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
s Connection with the DVD Extension Unit The WJ-HD500A Digital Disk Recorder controls the WJHDE510 DVD Extension Unit through the SCSI chain. The figure shows a WJ-HDE510 without an HDD. The DVD-RAM is used for backup of the data recorded on the WJ-HD500A Digital Disk Recorder. 1. Connect between the COPY port on the WJ-HD500A and the COPY IN port on the 1st DVD Extension Unit with the supplied (WJ-HDE510) SCSI cable. Plug the cable end with magnetic core into the COPY port, and the other ends into the COPY IN port. 2. Connect between the EXT STORAGE port on the WJHD500A and the EXT IN port on the 2nd Extension Unit with the supplied (WJ-HDE510) SCSI cable. Plug the cable end with magnetic core into the EXT STORAGE port, and the other ends into the EXT IN port. EXT STORAGE Digital Disk Recorder WJ-HD500A SCSI ID=6 and 7 IN SPOT OUT EXT STORAGE OUT MULTISCREENOUT AUDIO CONTROL 16 15 14 13 12 11 IN COPY port COPY DATA ALARM MODE 10 9 8 7 6 GEN-LOCK OUT REMOTE(WV-CU50) SERIAL SIGNAL GND 10/100BASE-T 5 4 3 2 1 OUT 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 VIDEO CONTROL port AC IN ON OFF POWER SCSI cable (supplied with Extension Unit) SCSI cable (supplied) COPY IN DVD Extension Unit #1 WJ-HDE510 SCSI ID= not set EXT IN EXT OUT HDD INSTALLED NOT INSTALLED COPY IN SCSI ID - 1 + TERMINATOR ON OFF G THERMAL ERROR OUT NC AC IN POWER ON OFF SIGNAL GND EXT IN EXT IN EXT OUT + - SCSI ID TERMINATOR ON OFF GND THERMAL ERROR OUT NC Terminal board AC IN POWER ON OFF SIGNAL GND The system can be expanded by up to 6 Extension Units. To connect the other Extension Units, refer to the operating instructions of each unit for further information. Extension Unit #2 WJ-HDE500/HDE505 SCSI ID=0 to 5 q Switch Settings 1. Set MODE switch #2 on the rear of the WJ-HD500A to OFF when connecting a DVD Extension Unit without an optional HDD. Set the MODE switch to ON if other Extension Units are installed in the system. 2. Set the SCSI ID and TERMINATION of the Extension Units as required. 1 2 3 4 ON MODE 22