Panasonic WJHD500A WJHD500A User Guide - Page 6

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS s Front View e t y u !0 r io !1 !2 !3 !4 !5 !6 !7 !8 !9 @0 w q REMOTE TIMER OPERATE ALARM ALARM RESET ALARM SUSPEND HDD FULL LOCK 1 SPOT MULTISCREEN 5 MULTISCREEN SELECT 9 2 3 4 SET 6 7 8 10 11 12 SEQUENCE 13 14 15 16 REC STOP REC PREVIEW EL-ZOOM SETUP /ESC COPY DAYLIGHT SAVINGS GROUP SELECT INDEX ALARM SEARCH DISPLAY STOP BPLAY/ PAUSE REC REV FWD FS 16 Digital Disk Recorder WJ-HD A #1 #0 @9 @8 @7 @6 @5 @4 @3 @2 @1 q Operate Indicator (OPERATE) Is on when the power of the WJ-HD500A Digital Disk Recorder is turned on. w Timer Indicator (TIMER) Lights to indicate when the TIMER is set to INT (internal timer) in the setup menu. e Remote Indicator (REMOTE) Lights to indicate when the Disk Recorder is controlled by an outboard device via the Serial or 10/100BASE-T port on the rear of the Disk Recorder. r Alarm Suspend Indicator (ALARM SUSPEND) Lights to indicate that the alarm suspension mode is selected. t Alarm Reset Button (ALARM RESET) This button cancels an activated alarm. Pressing this button will reset the alarm and return the system to the condition before the alarm function was activated. y Alarm Indicator (ALARM) This indicator blinks to indicate that an alarm condition exists. It changes to a steady light when the alarm is reset automatically. To turn the indicator off, press the ALARM RESET button. u Sequence Button (SEQUENCE) Runs the assigned sequence on the selected monitor screen for the specified duration. During the sequence, pressing this button will pause the sequence that is being run on the monitor screen. 6 The LED indicates the status as follows. On: Sequence is being run. Blinking: Sequence is in pause mode. i Multiscreen Selection Button (MULTISCREEN SELECT) Selects the multiscreen pattern to be displayed on the Multiscreen Monitor that is connected to the MULTI SCREEN OUT on the rear of the Recorder. Pressing this button will toggle the display on the monitor screen as shown below. 4 → 7 → 9 → 10 → 13 → 16 → 4 screen segments o Monitor Selection Button (SPOT/MULTISCREEN) Selects to control the display on the screen for either the Spot or Multiscreen Monitor. Pressing this button will toggle the indicator in the button on and off to indicate the selected monitor as shown below. On: Indicates the Spot monitor is selected. Off: Indicates the Multiscreen monitor is selected. !0 Lock Button (LOCK) Toggles to enable or disable the button lock function on both front panels of the Disk Recorder and Remote Controller. The LED indicates the status as shown below. On: The button lock is enabled. Off: The button lock is disabled. While On, the button lock will be released only if the preset password is entered in the password inquiry window.