Panasonic WJHD500A WJHD500A User Guide - Page 69
Network Setup, Stop Bit, Wait Time
View all Panasonic WJHD500A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
q Stop Bit This item lets you set the number of stop bits for RS-232C communication. 1. Move the cursor to the STOP BIT parameter by pressing the D or C button. 2. Select either 1 or 2 for the number of stop bits by pressing the + or - button. The factory default setting is 1 bit. q Wait Time This item lets you set the waiting time in milli-seconds (ms) to retry after confirming that no data is received from the controller for RS-232C communication. 1. Move the cursor to the WAIT TIME parameter by pressing the D or C button. 2. Select OFF, 100, 200, or 1 000 ms for the wait time by pressing the + or - button. When no transmission is needed, select OFF. The factory default setting is OFF (no retry). s Network Setup When the optional Network Board is installed in the Disk Recorder, the Disk Recorder can be controlled from a Client PC via the Ethernet Hub. These items let you set the parameters for communication between the 10/100BASE-T port of the Disk Recorder and outboard device via Ethernet. 1. Move the cursor to IP ADDRESS in the COMMUNICATION SETUP menu by pressing the C or D button, then press the SET button. The cursor moves to the right editing area. 2. Select the value for the IP Address by pressing the + or - button. 3. Move the cursor to the right by pressing the B button, then select the value for the IP Address by pressing the + or - button. 4. Repeat the above steps 2 and 3 until the IP Address is completed. 5. When the IP Address is completed, press the SETUP/ESC button to return the cursor to IP ADDRESS in the menu. 6. Similarly repeat the above steps 1 to 5 to set the Netmask and Gateway. 7. To return to the previous setup menu, press the SETUP/ESC button. 71