Panasonic WVCS564 WVCS564 User Guide - Page 32

q Synchronization (SYNC) 1. Display SET UP on the monitor screen. If necessary, refer to Setup Menu Display on page 16 for details on displaying the SET UP menu on the monitor screen. 2. Move the cursor to SYNC and select line-lock (LL) or internal (INT) by using the joystick. The factory default setting is INT. Important Notices: 1. The priority of SYNC modes is as follows: 1. Multiplexed vertical drive (VD2) (highest priority) 2. Line-lock (LL) 3. Internal sync (INT) (lowest priority) 2. To use internal sync, select INT. 3. Whenever the vertical drive pulse (VD2) is supplied to the camera, the camera sync mode is automatically switched to the multiplexed vertical drive (VD2) regardless which sync mode is selected. Line-lock Sync Mode (LL) 1. Display SET UP on the monitor screen. (Refer to Setup Menu Display on page 16 for details on displaying the SET UP menu on the monitor screen.) 2. Move the cursor to SYNC and select LL by using the joystick. LL sync mode is not available when the multiplexed vertical drive (VD2) pulse is supplied. 3. After selecting LL, press the CAM (SET) key. The SYNC menu appears on the monitor screen. 4. Supply the video output signal of the camera to be adjusted and the reference camera video output signal to a dual-trace oscilloscope. 5. Set the dual-trace oscilloscope to the vertical rate and expand the vertical sync portion on the oscilloscope. 6. Move the cursor to COARSE by using the joystick. Camera setting menu ** SET UP ** CAMERA ID ON ALC/MANUAL ALC SHUTTER OFF AGC ON(MID) SYNC INT WHITE BAL ATW AF MODE MANUAL S EL-ZOOM ON IMAGE HOLD OFF RET SPECIAL Camera setting menu ** SET UP ** CAMERA ID ON ALC/MANUAL ALC SHUTTER OFF AGC ON(MID) SYNC LL WHITE BAL ATW AF MODE MANUAL S EL-ZOOM ON IMAGE HOLD OFF RET SPECIAL SYNC menu ** SYNC ** V PHASE COARSE 1(1--16) FINE - + RET 33