Panasonic WVCS574 WVCS574 User Guide - Page 48

10. Move the cursor to RET and press the CAM (SET) button to return to SET UP. ● Auto Focus Setting (AF MODE) 1. Move the cursor to AF MODE, and select the following mode with the joystick. S, M and L stand for Small, Middle and Large areas respectively in the center of a scene that are used for sensing sharpness in auto-focusing. ** SET UP ** CAMERA ID OFF ALC/MANUAL ALC SHUTTER AUTO AGC ON(MID) SENS UP OFF SYNC INT WHITE BAL ATW1 MOTION DET OFF AF MODE AUTO L RET SPECIAL2 AUTO S AUTO M AUTO L MANUAL L MANUAL M MANUAL S Important Notices: • The motion detection should meet the following conditions. 1) The picture size on the screen should be larger than 1/48 of the actual picture size. 2) The contrast ratio between the object and the background picture should be more than 5 % at the maximum detection level. 3) The time that takes the object to move from one end of the screen to the other should be more than 0.1 second. • Also under the following conditions, mask or adjust the detection level to prevent malfunction. 1) When leaves, curtains, etc. are swayed by the wind. 2) When a picture has a high noise content due to low light conditions. 3) When the object is illuminated by lighting equipment that constantly turns on and off. • The alarm signal will take approx. 0.2 seconds to reach the alarm terminal of the VCR after the camera detects the object. Because the alarm signal is multiplexed on the video signal, it may be mistakenly interpreted by other video equipment as a time code signal. Therefore, when this camera is not used in a Panasonic Intelligent CCTV System, select OFF to prevent the above from occurring. MANUAL S, M, L: Auto focus is activated only when the button that is assigned for the auto-focus function on the controller is pressed. AUTO S, M, L: Auto focus is activated automatically while the pan, tilt or zoom operation is manually performed. These may be selected in the same way as MANUAL by pressing the button that is assigned for the auto-focus function on the controller. 2. To confirm auto-focus operation, press CAM (SET) button. Notes: • When the electronic sensitivity enhancement (SENS UP) is activated except in the x2 FIX or x2 AUTO mode, this function is automatically set to MANUAL (S, M, L). • The auto focus lens does not function properly in the AUTO mode after using the WIDE lens. • The auto focus lens may not function properly in the AUTO mode under the following conditions. 1. Dirt or water on window glass. The auto focus may focus on the dirt or water. 2. Low lighting or illumination. 3. Bright objects or high intensity objects. 4. Single color object such as a white wall or fine felt 5. No center objects and sloping objects 6. Far and near objects on the screen -48-