Pioneer AVIC N4 Owner's Manual - Page 155

NAVI/AV Appendix Message Speed pulse wire is not connected. System will start to learn without speed pulse. Please keep in mind that accuracy is not fully ensured without speed pulse. When The speed signal input (pink lead wire) of the power cable is not connected. Vibration is detected. Please power The navigation unit is installed in a off the system and check the installa- place where it may be affected by a tion. After you have checked, please large vibration. re-boot the system and press "OK". Direction of G sensor is not correct. Please power off the system and check the installation. After you have checked, please re-boot the system and press "OK". Direction of G sensor is set incorrectly. Gyro Sensor is not working properly. Abnormal output is detected from Please consult your dealer or Pioneer the Gyrosensor. service center. This function is not available now. System detected that the vertical angle of the installation has been changed. Learning status for Gyro Sensor has been initialized. System detected that the vertical angle of the installation exceeds the permission level. Please install the navigation unit correctly. The screen cannot be displayed with Vehicle Dynamics Display. Because the sensor has not been taught so the sensor information cannot be acquired. If the mounting angle of the navigation unit has been changed. The navigation system is installed with an extreme angle exceeding the limitation of the installation angle. No data available at this time. No XM signal. Please wait. XM updating. Please wait. If no data is available that can be used with the XM tuner. While waiting for a response from the XM tuner. You are in an area that cannot receive XM tuner reception. Your current location provides very poor reception. Service subscription is either XM audio only or XM NavTraffic stand alone. UPDATING Radio is being updated with the latest encryption code. The selected channel is not included in your subscription. Radio is being updated with the latest encryption code. What to do To operate with 3D hybrid mode, connect the speed signal input (pink lead wire) of the power cable correctly. Although it can be operated with Simple hybrid mode without connecting the speed signal input, the precision of the positioning will be less accurate. Re-install the navigation unit in a place where the unit will not be affected by vibration. See the "Installation Manual" and set the direction of the navigation unit correctly. Note down the error code shown on the screen. Turn off the power, and then contact your nearest Pioneer service facility. If the sensor learning status reaches the Sensor Initializing status, the system is ready to be used. The system initializes the sensor in order to operate it with the maximum performance and automatically starts re-learning. Confirm the installation angle. (The navigation system must be installed within the allowed installation angle. For details refer to Installation Manual.) Wait for a while and try the operation again. Wait for a while and try the operation again. Move into an area that can receive XM tuner reception. Change your location. Since the GEX-P10XMT is capable of receiving both XM audio and XM NavTraffic service, if you are subscribed to only one or the other, the system checks to see if you have added another service to your account since you last powered on the navigation system. When you subscribe to both services, this message will stop appearing when you turn the ignition ON (ACC ON). Wait until the encryption code is fully updated. Select another channel. Wait until the encryption code is fully updated. 153