Pioneer DVR-640H-S Owner's Manual - Page 129

Additional information 15 Message • This content is copy protected. • Incorrect CPRM information. • Repairing disc. • Repairing the HDD. • Could not repair the disc. • Overheating has stopped operation. Press DISPLAY to clear this message. • HDD optimization is recommended. This can be done using Disc Setup. • Please perform HDD optimization. This can be done using Disc Setup. • The HDD has not been sufficiently optimized. Please optimize again. Searching for printer. Please wait a moment. The printer is not ready or there is no printer connected. Please check the printer status. Explanation/Action The video source is copy-protected and cannot be recorded. The recorder could not read the CPRM information. The recorder may be damaged- please consult a Pioneer Service Center. During recording, the power was cut. This display appears when the power is restored. The recorder was unable to repair the disc after a power cut. The contents of the recording will be lost. The internal temperature of the recorder has exceeded the operating limit. If this message reappears, please contact a Pioneer authorized service center. The HDD should be optimized (basically, HDD housekeeping) to maintain playback and recording performance. The HDD is in more urgent need of optimization in order to maintain performance. If this message appears repeatedly after optimizing the HDD it is likely that there is not enough free space on the HDD for optimization to complete properly. Please erase some titles from the HDD and optimize again. This message is displayed when the recorder is scanning for a connected printer, or when the printer is not yet ready for printing. If there is no printer connected, please connect one. This message is displayed when communication could not be established with the printer. See the Troubleshooting section if you do not know the cause. 129 En