Pioneer PRO-1010HD Owner's Manual - Page 14

English Installation and Connections Installation of the Unit Installation using the optional PIONEER stand or installation bracket ÷ Please be sure to request installation or mounting of this unit or the installation bracket by the dealer where purchased. ÷ When installing, be sure to use the bolts provided with the stand or installation bracket. ÷ For details concerning installation, please refer to the instruction manual provided with the stand or installation bracket. Installation using accessories other than the PIONEER stand or installation bracket (sold separately) ÷ When possible, please install using parts and accessories manufactured by PIONEER. PIONEER will not be held responsible for accident or damage caused by the use of parts and accessories manufactured by other companies. ÷ For custom installation, please consult the dealer where the unit was purchased. Air vents (fan) Wall-mount installation of the unit This unit has been designed with bolt holes for wallmount installation, etc. The installation holes that can be used are shown in the diagram below. ÷ Be sure to attach in 4 or more locations above and below, left and right of the center line. ÷ Use bolts that are long enough to be inserted 1/2 inch (12 mm) to 11/16 inch (18 mm) into the main unit from the attaching surface for both a holes. Refer to the side view diagram below. ÷ As this unit is constructed with glass, be sure to install it on a flat, unwarped surface. CAUTION To avoid malfunction, overheating of this unit, and possible fire hazard, make sure that the vents on the main unit are not blocked when installing. Also, as hot air is expelled from the air vents, be careful of deterioration and dirt build up on rear surface wall, etc.. CAUTION Please be sure to use an M8 (Pitch = 1.25 mm) bolt (Only this size bolt can be used). Attaching surface a hole a hole Main unit Center line Installation bracket, etc.. a hole Bolt 1/2 inches (12 mm) to 11/16 inches (18 mm) Installation and Connections Center line Rear view diagram (PRO-1010HD) Side view diagram Air vents (fan) a hole a hole Center line Rear view diagram (PRO-810HD) CAUTION This display unit weighs at least 67 lbs (30 kg) and has little front-to-back depth, making it very unstable when stood on edge. As a result, two or more persons should cooperate when unpacking, moving, or installing the display. Center line CAUTION This unit incorporates a thin design. To ensure safety if vibrated or shaken, please be sure to take measures to prevent the unit from tipping over. 7 Optional line (sold separately) (For details, please consult the dealer where this unit was purchased.) 1 Table top stand : PRO-1010HD / PRO-810HD display stand. 2 Wall installation unit : Wall installation bracket designed as a wall interface for securing the unit. 10 EN