Pioneer PRO-1010HD Owner's Manual - Page 52
Additional Information - problems
View all Pioneer PRO-1010HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Additional Information English Additional Information Cleaning Troubleshooting Regular cleaning will extend the life and performance of this unit. The recommended way to clean the display and related parts is described below. Before cleaning, be sure to unplug the power cord from the power outlet. Cleaning the display panel body and remote control Do not under any circumstances use solvents such as benzine or thinner for cleaner. Use of such liquids may cause deterioration or peeling of paint from the display or remote control unit. Wipe the display and remote control gently with a soft cloth. In the case of excessive dirt buildup, dampen a soft cloth with a diluted neutral cleaning detergent and after wringing the cloth thoroughly, wipe the component and then dry it with a dry soft cloth. Cleaning the screen After dusting, wipe the screen gently using the supplied cleaning cloth or a soft cloth. Do not use tissue or a rough cloth. As the surface of the screen is easily scratched, do not rub it or hit it with a hard object. What may at first seem to be an malfunction, may be remedied with a quick check. Please check to see a warning is displayed on the screen. If displayed, refer to the table below and check the mode. If there is no display check to see the problem is listed on page 49. The problem may also be caused by something other than this unit so please also check the other components being used such as a video deck. If the problem can still not be solved please consult the dealer where this unit was purchased. About the self diagnosis mode Messages appear on the center of this unit's screen to indicate operation or connection faults. After message confirmation, check the condition of the unit. ERROR MESSAGE REMEDY CAUTION OUT OF RANGE or CAUTION UNSUPPORTED SIGNAL or SIGNAL NG ¶ The current input signal is not supported by the unit. Check the Computer signal compatibility table on pages 53 to 54, and change the computer's output signal setting appropriately. Cleaning the vents As a general rule, use a vacuum cleaner about once a month to clean the vents on the rear panel of the display of dust buildup (set the vacuum cleaner to its weakest setting when doing this). Using the unit without cleaning it of dust will cause the internal temperature to increase, resulting in possible breakdown or fire. Vents WARNING THERMAL ALERT SHUT DOWN (**) WARNING FAN FAILURE SHUT DOWN (**) ¶ Turn off main power (page 9). ¶ Is ambient temperature too high? ¶ Remove any objects blocking the cooling vents on the plasma display. ¶ Cooling fan has malfunctioned. Immediately turn off power, remove power plug from its outlet, and consult a Pioneer service center or your dealer. Vents Vents Vents ERROR INVALID KEY ENTRY ¶ An invalid operation has been attempted. Check input signals, connections and other settings (for example, multiscreen). Vents Illustration depicts PRO-1010HD model. SHUT DOWN (**) ¶ Turn off main power, wait for 1-2 minutes, then try turning power on again. If problem persists, remove power plug from its outlet and consult a Pioneer service center or your dealer. In the above, messages contents indicated by (**) 48 represent numerals. EN