Pioneer PRO-1010HD Owner's Manual - Page 43

English Picture and Screen Adjustment Adjusting Screen POSITION, CLOCK, and PHASE (Automatic Adjust) During PC signal input, by pressing the AUTO SET UP button on either remote control unit or the unit's operating panel, the unit will automatically set the screen position, clock and phase to best match the current image input. When the button is pressed, the optimum settings are automatically selected for the current input source. AUTO SET UP Adjusting Screen POSITION, CLOCK, and PHASE (Manual Adjust) Follow the procedure to save adjustment values for each INPUT. MENU 5/∞ 2/3 SET MENU 2/3 SET 5/∞ Remote control unit AUTO SET UP Display operating Panel Press the AUTO SET UP button on either the display or remote control unit. Display operating panel Remote control unit 1 Press the MENU button to display the menu screen. S TA N D A R D PICTURE SCREEN CONTRAST : BRIGHTNESS : H. ENHANCE : V. ENHANCE : SETUP 0 0 0 0 INPUT1 OPTION PICTURE RESET Picture and Screen Adjustment AUTO SET UP Notes ÷ This setting is supported only when a computer signal is connected to INPUT1 (D-sub) or INPUT5. ÷ Perform this adjustment individually for each input function (INPUT1 (D-sub) or INPUT5), and each signal type. ÷ Optimum settings may not be possible for low-luminance and certain other signals. In such cases, use the adjustment methods explained on the this page, "Adjusting Screen POSITION, CLOCK, and PHASE (Manual Adjust)". ÷ If you run AUTO SET UP, POSITION, CLOCK and PHASE are automatically set even if you manually adjust them following the procedures in the next section. SET ENTER MENU EXIT 2 Use the 2/3 buttons to select [SCREEN]. (MENU during PC signal input via INPUT1 or INPUT5.) S TA N D A R D PICTURE SCREEN SETUP POSITION CLOCK PHASE SIZE : 00 :0 : 0 : 00 INPUT1 OPTION SCREEN RESET SET ENTER MENU EXIT 39 EN