Pioneer VSX-49TX Owner's Manual - Page 116

Techno Tidbits & Problem-solving Problem When playing a DTS format LD there is noise audible on the soundtrack. Can't record audio. Cause • The SIGNAL SELECT is on ANALOG. • You are trying to make an analog recording from a digital signal, or a digital recording of an analog source. • The digital source is copy protected. • The REC jacks have not been connected properly. Remedy • Set the SIGNAL SELECT to DIGITAL (p.51). • You can only record analog to analog, or digital to digital. • You can't record digital sources that have been copy protected. • Check all connections. Video The Setup screen doesn't appear. • See same problem on p.113. No image is output when an input is selected. • Improper connections. • The input source on the TV monitor is not properly selected. After connecting the TV and selecting the proper video input, there is still no image. • The video input selected on the TV monitor is incorrect. There is no image coming from the selected component video jacks. • The COMPONENT VIDEO IN setting is incorrect. • The cord connect to the TV is composite or S video. Can't record video. • You are trying to record a source connected to the component video jacks. • The source is copy protected. • Make sure the component is connected correctly (p.20-22). • Select the correct function. • Please read the TV monitor manual and change the settings accordingly. • Select the correct COMPONENT VIDEO IN setting (p.94). • Use a component video cord to connect to the TV as well (see p.19). • Connect the source component to either the composite video, or the S video jacks (p.19). • You can't record sources that have been copy protected. Input/display The display is dark. You can't change the device input even when you press the function key on the remote. You can't get DIGITAL or 2 RF to come up when using the SIGNAL SELECT button. The digital format indicator doesn't light up even when playing a non-PCM digital source. • The DISPLAY DIMMER button is pushed. • DIRECT FUNCTION is set to OFF. • Press DISPLAY DIMMER on the remote control repeatedly to return to the default setting (p.62). • Switch DIRECT FUNCTION to ON (p.74). • Either the digital connections or the DIGITAL IN setting is incorrect. • Tape 2 MONITOR is on. • MULTI CH IN mode is on. • You're in an unassigned i.LINK function. • The player is paused or stopped. • There is a mistake in the player settings for audio output. • Make sure the digital connections and the DIGITAL IN setting (p.93) is done correctly. • Press the Tape 2 MONITOR button so it goes into the off setting (p.60). • Turn MULTI CH IN mode off (p.59). • Select the correct input function or set the i.LINK input correctly (p.95). • Play the source. • Fix the audio settings (check the manual that came with your DVD player). 116