Pioneer VSX-49TX Owner's Manual - Page 81

MULTI-ROOM setup 1 2 RECEIVER DVD/LD VCR1 /DVR VCR2 Receiver MAIN SUB REMOTE SETUP LISTENING MODE SURROUND STEREO /DIRECT THX STANDARD (DVD-A /SACD) MULTI CH IN CD CD-R/ TAPE1 TUNER ADVANCED ADVANCED CINEMA CONCERT LISTENING CH SEL. VIDEO VCR3 TV MIDNIGHT DIGITAL NR SAT ACOUSTIC CAL. TV CONTROL RECEIVER DVD/LD Receiver TONE BASS/ ATREBLE VCR1 /DVR VCR2 VCR3 TV DISPLAY DIMMER STATUS SYSTEM SETUP VIDEO SELECT SPEAKER A/B MAIN SUB EFFECT/ CH SEL. LOUDNESS TAPE 2 MONITOR INPUT ATT. SIGNAL SELECT REMOTE SETUP CD CD-R/ TAPE1 TUNER VIDEO SAT TV CONTROL 3 3 System Setup [Auto Surround Setup] [1. Input Assign ] [2. Surround Setup ] [3. Expert Setup ] [4. THX Audio Setup ] 4 3.Expert Setup [1. OSD Adjustment ] [2. Bass Peak Level ] [3. D-Range Control ] [4. Multi-Ch In Select ] [5. Function Rename ] [6. Hi-bit/Hi-Sampling ] [7. Multi-Room Setting ] [Return] 5 3.7. Multi-Room Setting Volume Level [VARIABLE] IR Receiver [PIONEER ] [Return] 3.7. Multi-Room Setting Volume Level [ FIXED ] IR Receiver [PIONEER ] [Return] 6 3.7. Multi-Room Setting Volume Level [VARIABLE] IR Receiver [ OTHERS ] [Return] 7 3.7. Multi-Room Setting Volume Level [VARIABLE] IR Receiver [ OTHERS ] [Return] CAUTION: If the "FIXED" position is chosen,the volume will be loud. Using Other Functions 1 Turn on the receiver and your TV then, press RECEIVER on the remote control. Make sure your TV is set to the receiver. 2 Press the SUB button on the remote control. 3 Press the SYSTEM SETUP button then select EXPERT SETUP using 5 and ∞. Press ENTER. The EXPERT SETUP menu appears on the OSD. 4 Use the 5∞ buttons to select MULTI-ROOM SETTING. Press ENTER. 5 Select the VOLUME LEVEL by selecting VARIABLE or FIXED. If you hook up a just a power amplifier in the sub room the VSX-49TX will act as a pre-amp. In this case choose VARIABLE for the VOLUME LEVEL setting. If you hook up a full integrated amplifier in the sub room (such as another Pioneer VSX receiver) choose FIXED for the VOLUME LEVEL setting. CAUTION! If the MULTI ROOM is set to FIXED the volume on the main unit will be set to maximum. Thus, when output, it will be extremely loud. Please set the master volume controls of the integrated amplifier in the sub room very low at first and experiment to find the correct volume. 6 Select the IR RECEIVER type. If you have an IR receiver from a different company than PIONEER, select OTHERS. If you have the Pioneer-made MR-100, or the IR receiver you're using doesn't seem to work after selecting OTHERS, select PIONEER. 7 Select RETURN (use ∞5) and press ENTER to go back to the EXPERT SETUP. 8 Use the 5∞ buttons to select RETURN and press ENTER, again. Then, use the 5∞ buttons to select EXIT and press ENTER. memo There may be some IR receivers that can't be used with this receiver. Check with a PIONEER representative to be sure. 81 EXPERT