Pioneer VSX-816-S Operating Instructions - Page 19
Connecting up, Connecting the speakers - subwoofer
View all Pioneer VSX-816-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
English Deutsch Français Italiano Nederlands Español Connecting up 04 Connecting the speakers A complete setup of eight speakers (including the subwoofer) is shown here but everyone's home setup will vary. Simply connect the speakers you have in the manner shown below.1 The receiver will work with just two stereo speakers (the front speakers in the diagram) but using at least three speakers is recommended, and a complete setup is best. Make sure you connect the speaker on the right to the right terminal and the speaker on the left to the left terminal. Also make sure the positive and negative (+/-) terminals on the receiver match those on the speakers.2 You can use speakers with a nominal impedance between 6 Ω to 16 Ω (please see Switching the speaker impedance on page 63 if you plan to use speakers with an impedance of less than 8 Ω). Front speakers Center speaker L R C Surround speakers Surround back speakers LS RS SBL SBR DIGITAL OUT IN OPT IN OPT 2 (TV/ SAT) IN OPT 1 (CD) OUT ASSIGNABLE DIGITAL IN IN ASSIGNABLE DIGITAL IN IN COAX 2 (DVR/VCR) IN COAX 1 (DVD/LD) OUT R AUDIO CEN- SUB TER WOOFER AUX FM UNBAL 75 Ω CD DVR / VCR AM LOOP ANTENNA MONITOR OUT OUT CONTROL IN OUT R L SURROUND DVD 5.1CH INPUT IN TV / SAT IN DVD / LD FRONT D V D PLAY 5.1CH INPUT IN CD-R / TAPE / MD REC L VIDEO OUT MONITOR OUT DVR / VCR IN TV / SAT IN SR P E SUB WOOFER A DVD / LD A PREOUT IN S-VIDEO K E R S FRONT COMPONENT VIDEO (DVR/VCR)IN 3 ASSIGNABLE Y PB PR Y (DVD/LD) IN 1 PB PR TWO VOLTAGE SELECTORS FRONT L SURROUND SURROUND BACK L L PREOUT 220V 110V 240V 120 -127V MONITOR OUT LR SURROUND (TV/SAT)IN 2 R R L CENTER R SURROUND BACK L R CENTER B AC IN 110V 120 - 127V 220V 240V This receiver Powered subwoofer SW INPUT Caution • Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. Use good quality speaker wire to connect the speakers to the receiver. Note 1 If you're not using a subwoofer, change the front speaker setting (see Speaker Setting on page 42) to LARGE. 2 If you are using only one surround back speaker, connect it to the surround back left (L) terminal. 19 En