Pioneer VSX-816-S Operating Instructions - Page 63
Additional information, Resetting the main unit, Switching the speaker, impedance, Changing the TV
View all Pioneer VSX-816-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Additional information 14 English Deutsch Français Italiano Nederlands Español Problem Remedy The SR cable is connected, but • Reinsert the SR cable, making sure it's connected to the right jack (see Using this the connected components receiver with a Pioneer plasma display on page 56). can't be operated with the • Make sure an analog connection has been made between the units. remote. • This feature only works with Pioneer products. The display is dark or off. • Press DIMMER on the control repeatedly to return to the default. The System Setup screen doesn't appear. • When the receiver is in standby, switch to BURST.OFF by holding down ACOUSTIC EQ (front panel) and pressing STANDBY/ON (the current setting is displayed). USB mass storage device is not recognized by the receiver. • Try switching the receiver off, then on again. • Make sure you have completely inserted the USB connector to this receiver. • Check that the memory format is FAT16 or FAT32 (FAT12, NTFS and HFS are not supported). • USB devices with an internal USB hub are not supported. USB ERR3 shows in the display • If this message continues to appear after going through all the checks in when connecting a USB Important on page 34 of USB playback, take the unit to your nearest Pioneer device. authorized service center or your dealer for servicing. Can't play audio files. • The WMA or MPEG-4 AAC files were recorded using DRM (digital rights management), or the bit rate/sampling rate is not compatible (see Compressed audio compatibility on page 35). This is not a malfunction. Resetting the main unit Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down the TONE button, press and hold the STANDBY/ON button for about three seconds. 3 When you see RESET? appear in the display, press ENTER. OK? shows in the display. 4 Press SETUP to confirm. OK appears in the display to indicate that the receiver has been reset to the factory settings. Switching the speaker impedance We recommend using speakers of 8 Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6 Ω impedance rating. • With the receiver in standby, press STANDBY/ON while holding down the SPEAKERS button. Each time you do this, you switch between the impedance settings: • SP 6 OHM - Use this setting if your speakers are rated at 6 Ω. • SP 8 OHM - Use this setting if your speakers are rated at 8 Ω or more. Changing the TV format setting If the System Setup menu is not displayed correctly, it may be that the TV system is set incorrectly for your country or region. • With the receiver in standby, press STANDBY/ON while holding down the SIGNAL SELECT button. The display shows the new setting (PAL or NTSC). 63 En